emSTAMP-Neon Developer Kit

The emSTAMP-Neon Developer kit is a low-cost development kit including an emSTAMP-Neon module (with ST STM32F469NI microcontroller) in a form factor reminiscent of the famous Arduino Mega development kit. This kit allows for rapid prototyping and includes a number of interfaces to make the most of the emSTAMP-Neon.

You can find the most common connectors for development such as the JTAG ARM for Debugging and the 6pin connector for a USB cable / FTDI series.
In terms of connectivity, the emSTAMP-Neon Developer kit has compatibility with all Arduino expansion modules to build fast and inexpensive prototypes.

There is also an Ethernet connector and a USB host and device. It is also possible to use a micro SD card. Finally, the baseboard is equipped with an LCD connector for the Glyn EDT LCD range.

FreeRTOS can be installed by you with no additional costs, allowing you to start directly your evaluation and development on this module.

FreeRTOS STM32F469NI

Key features:

  • Microcontroller module: emSTAMP-Neon with ST STM32F469NI microcontroller (up to 180 MHz), 32 MB RAM und 16 MB QSPI NOR Flash
  • Operating System: FreeRTOS, optionally μClinux



Name Summary File
emSTAMP-Neon Hardware Manual Hardware Manual Microcontroller Module
Change date19.09.2019
TypeManual
LanguageEnglish
emSTAMP-Neon Software Manual Developer Kit Software Manual Developer Kit emSTAMP-Neon
Change date27.09.2018
TypeBSP
LanguageEnglish
emSBC-Neon Hardware Manual Hardware Manual emSBC-Neon
Change date24.05.2019
TypeBSP
LanguageEnglish


  • emSTAMP-Neon on carrierboard
  • with power-supply and pre-installed OS
  • Arduino compatible connector for extension boards
  • USB-Host, Ethernet
  • CAN at extension connector
  • size: 55x115mm


Name Summary
ADA-CAN_3V3 Adaptation cable with high-speed CAN transceiver from LVTTL interface to CAN (D-SUB9).

Details



Question
Running straight into _Error_Handler() after compiling the PinMux example

Details


Back